Create a direct SMA-to-SMA RF connection between compatible equipment with a factory-terminated 3 m coaxial assembly. VENTEV VENPJ-SPP-1818-3M uses SPP-250LLPL cable and provides an SMA male connector on each end. The matched connector arrangement supports installations where both connected devices present SMA female ports. The 3 m length suits equipment layouts where a short jumper will not reach but a longer cable would add unnecessary routing slack. Typical applications include linking radio equipment, antennas, surge-protection components, RF distribution hardware, and test equipment that use SMA interfaces. Verify connector gender and the required cable path before installation, since both ends are male SMA. SPP-250LLPL identifies the cable construction used in this assembly, while the part's 3M suffix identifies its finished length. This is a terminated cable assembly rather than loose bulk cable, allowing the connection to be installed without field-fitting SMA connectors. Route the cable with appropriate bend clearance and secure it along the path to avoid strain at either SMA interface.