Carry an RF connection between equipment with a 4.3-10 port and equipment with an N port using a short coaxial jumper with male right-angle connectors at both ends. The 1.5 ft assembly provides a close-coupled link where the two connection points are located near one another. Its TFT-402-LF designation identifies the cable construction specified for this assembly. The 4.3-10 male end mates with a corresponding female 4.3-10 interface, while the N male end mates with a corresponding female N interface. Right-angle connector orientation directs the cable away from each connector face rather than extending the connection straight outward. This arrangement helps route a jumper where available depth behind a radio, antenna component, or other RF device is restricted. VENTEV 615563 combines the specific 4.3-10 male-to-N male interface pair with right-angle terminations on both ends and a 1.5 ft cable length. Check both equipment-side interfaces for the required 4.3-10 and N female connections before installation. The short assembly is intended for direct equipment-to-equipment links rather than a long cable run, helping keep excess cable out of a compact RF connection path.