Carry 100 Gbps optical traffic across short single-mode runs with a 1 m cable that combines OS2 fiber, MTP/APC female connectivity, and plenum-rated construction. The 16-fiber MTP format concentrates a parallel optical connection into one cable assembly, reducing the number of individual fiber leads that must be routed between compatible equipment. APC connector geometry is specified for the optical interface, so endpoint connector type and polarity must match the installed link. StarTech OS2MTP16BOFNP1M fits high-density optical cabling where a very short interconnect is needed inside a plenum pathway. Its 1 m length suits adjacent equipment, patching sections, or tightly located optical panels where excess cable can complicate routing. OS2 single-mode fiber addresses installations built around single-mode infrastructure, while the female MTP/APC interface targets compatible multi-fiber optical ports and trunks. It is not a copper network patch lead; both the connector interface and fiber type need to be matched at each end. What distinguishes this configuration is its combination of 16 fibers, OS2 single-mode construction, MTP/APC female termination, plenum jacket rating, 1 m length, and stated 100 Gbps support. Those details matter when selecting a parallel-fiber cable: a connector that mates physically but has a different polish, fiber type, polarity, or cable length does not create an equivalent assembly. Use it where the installed pathway permits plenum-rated cable and connected equipment is specified for the same MTP/APC, OS2, and 16-fiber arrangement.