Connect switches, workstations, access points, IP cameras, LED signage, and other RJ45 network endpoints across a 7 ft equipment-area run. The StarTech CAT6UTP7FTPL carries Cat6 Ethernet traffic at up to 10 Gbps and supports up to 100 W Power over Ethernet under IEEE 802.3bt Type 4, allowing one cable to carry data and PoE power to a compatible endpoint. Patching between a PoE switch or injector and an endpoint calls for cable construction that maintains signal quality and withstands routine moves. This cable uses 24 AWG stranded, pure bare copper conductors in an unshielded twisted-pair layout. Its 6.0 mm outside diameter and CM-rated PVC jacket suit general installations, while gold-plated RJ45 contacts provide the connector interface at both ends. Snagless connector boots protect the RJ45 latch during cable routing and removal from crowded network hardware. Purple insulation gives installers a visible way to separate this run from differently colored patching, and the 7 ft length addresses short equipment-to-endpoint connections without excess slack. Fluke DSX-8000 Channel testing adds a named cable-performance test point for deployments where link quality matters.