Panorama C29FP-5SP-GNSS FME Male to SMA Male 5m CS29 Coax Cable | GNSS Antenna Cable

The Panorama C29FP-5SP-GNSS is a 5 m (16.4 ft) factory-built CS29 coaxial cable assembly, fitted with a compact FME male plug on one end and a threaded SMA male plug on the other. It is built for GPS/GNSS antenna runs in telematics and fixed installations, where every dB of cable loss comes straight off your link budget. Panorama's CS29 cable is double-screened 5 mm coax with a stranded centre conductor and semi-air-spaced dielectric, running at the 50-ohm impedance used across cellular, GNSS and Wi-Fi RF paths. The stranded centre conductor keeps the cable flexible for tight routing, while the double screen holds attenuation low across cellular, GNSS and ISM frequencies. Because both connectors are terminated and tested at the factory, you avoid the loss and reliability penalties of field crimping. On the equipment side, the SMA plug mates with the SMA female antenna ports found on most cellular routers and gateways from Cradlepoint, Teltonika, Digi and Peplink. At the other end, the FME plug connects to FME female cable ends and antenna tails; the small FME head is designed to pull through tight grommets and panel holes first, then terminate or adapt as needed. Factory-applied GNSS identification labels identify the GNSS feed at a glance, which matters once several near-identical black cables share a conduit, headliner or cabinet. Typical uses include feeding a roof-mounted GNSS antenna to a router or gateway with GPS input and fleet telematics installs where the GNSS line must stay identifiable in a cable bundle. Route the cable with gentle bends, avoid crushing it under cable ties, and snug threaded connectors evenly to keep the RF joint consistent. For IT teams and installers, a pre-terminated Panorama assembly is the fast path to a clean, repeatable install: pick the length, match the connectors, and skip the crimp tooling entirely.