Carry an external RF antenna connection over a 20 ft cable run while retaining N-type terminations at both ends. The ACCORTEC CAB002L240N-ACC uses low-loss coaxial construction for antenna paths where cable attenuation matters. A straight N connector terminates one end, while a 90-degree N connector terminates the other. That mixed connector geometry supports installations where one cable entry must run directly outward and the other must turn immediately to follow an enclosure wall, mast route, or equipment-panel path. The right-angle end can reduce the clearance required behind a radio, antenna interface, or other N-type connection point. Its 20 ft length provides reach between separated equipment and external antennas without joining multiple short cable sections. Use this cable where the attached equipment and antenna both require N-type connector interfaces and the installation benefits from one straight and one right-angle termination. The defining configuration is its low-loss construction, 20 ft cable length, and unequal connector orientations. It is suited to fixed antenna paths in wireless networking and RF installations where cable routing is as important as connector compatibility.