Connect a cellular signal booster or modem to an external antenna covering 698–960 MHz and 1,710–2,700 MHz. Wilson Electronics 314405 supports cellular voice and 4G data applications using LTE, CDMA, GSM, UMTS and AWS technologies within its operating bands. Omnidirectional reception provides 360° horizontal coverage without aiming the antenna toward a particular tower. Vertical polarization and 50 ohm impedance define its electrical interface, while a 100 W maximum power rating establishes its power-handling limit. This antenna supplies the cellular RF connection for compatible equipment; the connected booster or modem handles the communication functions.
Fit the antenna to a permanent NMO mount on a car, truck or RV. The black, high heat ABS radome measures 3.3 inches high and 1.44 inches in diameter, giving the installation a low exterior profile. The required NMO mount is sold separately, with compatible mounting options including 901150 and 905814. RG58U cable belongs to the separate mount assembly. This antenna is commonly used with the weBoost Drive Reach Fleet booster kit, making it relevant to fleet vehicles that need an external cellular antenna.
Use the same antenna format for indoor or outdoor M2M installations connected to cellular modems or signal boosters. Its band-dependent peak gain ranges from 0.9 to 3.2, with separate electrical measurements for four frequency intervals. Cable selection matters because the specified loss for a 14 ft RG-58 run increases from 1.7 dB in the lowest measured interval to 3.4 dB in the highest. A two-year limited warranty covers the antenna.