Connect remote industrial equipment through cellular, wired or wireless networks with the Teltonika RUT241094000. LTE Cat 4 supports up to 150 Mbps download and 50 Mbps upload, while one WAN port and one LAN port each operate at 10/100 Mbps. Wi-Fi 4 supports access point and station modes, hotspot access and up to 50 simultaneous connections. Automatic failover between mobile, wired and Wi-Fi WAN connections gives remote sites an alternate network path when their primary connection fails. Integrate controllers and telemetry devices using Modbus TCP, MQTT, BACnet/IP, OPC UA and DNP3 over TCP. One digital input and one open collector digital output support event rules with email, SMS and RMS notifications. WireGuard, OpenVPN and IPsec provide VPN options for remote access, while VLAN separation, firewall rules and mobile data limits support traffic control. RutOS runs on a 580 MHz processor with 128 MB of DDR2 RAM and 16 MB of flash. RMS supports remote monitoring and firmware or configuration updates across multiple devices. Fit the compact aluminium enclosure into control cabinets or equipment installations: the chassis measures 83 × 25 × 74 mm and weighs 125 g. Operation from -40 °C to 75 °C suits sites with wide temperature changes. The 4-pin industrial connector accepts 9–30 V DC and carries the digital I/O connections. Passive PoE offers an alternative power path through LAN1, with maximum power consumption below 6.5 W. Two SMA cellular connectors and one RP-SMA Wi-Fi connector provide external antenna connections. DIN rail, wall and flat surface mounting require additional kits.