Extend a power connection across a 240 in run while keeping a low-profile device-side cable exit. LIND ELECTRONICS CBLOP-F00058 has bare wires at the adapter end and a right-angle 2.5 x 5.5 mm barrel connector at the device end. This configuration supports equipment that accepts the specified barrel connector while allowing the adapter-side conductors to be terminated for the installation. The 20 ft cable length provides routing distance between a power adapter and connected equipment where a short output lead cannot reach. Its right-angle barrel plug directs the cable alongside the device rather than straight out from the connector, which can help where clearance behind equipment is limited. The bare-wire adapter end is suited to installations that need a custom connection or replacement termination rather than a pre-fitted adapter connector. Match the device input connector to the 2.5 x 5.5 mm barrel dimensions before installation. Because the adapter end uses loose conductors, verify polarity, voltage, current capacity, conductor requirements, and the required termination method before making the connection. This cable supplies the physical output-cable arrangement; it does not change the electrical characteristics of the connected power adapter.