Inseego J-Arm Mount for Wavemaker FW2000e, FW2010e and FW3000 Outdoor CPE

Outdoor 5G CPE performs best when it is mounted high and aimed precisely. The Inseego J-arm mount is the optional mounting accessory Inseego specifies for its Wavemaker FW2000e, FW2010e and FW3000 outdoor units. It gives installers a firm, adjustable base on roofs and exterior walls. The mount is adjustable and fits vertical, horizontal and slanted exterior surfaces. The base attaches with four roof-mount lag screws, one in each corner, into pre-drilled holes. For concrete or brick, Inseego's installation guide calls for concrete anchors. The CPE fastens to its device elevation bracket, which then bolts to the J-arm with square neck bolts tightened to 2.0 Nm (1.48 ft/lb). For aiming, positioning bolts on the device elevation bracket and at the bottom of the mount adjust the horizontal and vertical angle. Installers typically use the Inseego Mobile app to read signal while fine-tuning. Once the best orientation is found, the positioning bolts are tightened to 15.0 Nm (11 ft/lb) to hold it in place. The flex-and-rotate design makes repositioning straightforward and stays firm once set. The bracket weighs approximately 2 lb and is made in Taiwan. Use it only with the Inseego FW2000e, FW2010e and FW3000.