The 1457J1601E is an 84 mm-wide, 28 mm-high EMI/RFI shielded enclosure from the 1457-EMI series, built on a 160 mm extruded aluminum body and specified at 6.3 in x 3.3 in x 1.12 in (160 mm x 84 mm x 28 mm). It suits OEM engineers and integrators housing a PC board or interface electronics in a shielded metal case. This version pairs a clear anodized extrusion with flat end panels (no mounting flanges).

The body is one piece of extruded aluminum 6063 with a minimum wall thickness of 0.06" (1.5 mm), and the end panels are easy-to-machine ADC-12 die-cast aluminum. The extruded body carries a clear anodized finish, while the die-cast end panels are painted in a durable black satin powder paint for a two-tone look. Each end panel is sealed with a full-perimeter conductive foam/fabric gasket made of Ni/Cu (nickel/copper) with CPSA (conductive pressure sensitive adhesive), and the assembly is rated IP54. A 0.75 mm (.030") deep recess on the body accepts a label or membrane keypad.

Boards slide horizontally into slots extruded into the body; the series table lists a maximum PCB of 160 x 80 mm, and the part data gives a maximum board of 159 x 79 mm. The drawing shows an inside face-to-face dimension of 160.00 mm [6.299 in], an internal section of 81.00 ±0.75 mm [3.189 ±0.030 in] wide by 24.00 ±0.60 mm [0.945 ±0.024 in] high, and an overall length of 171.15 mm [6.738 in]. At 28.50 mm tall, the J body suits thin single-board assemblies.

The 1457J1601E ships as a complete assembly: body, two end panels, two adhesive conductive end plate gaskets, #6 Taptight thread-forming screws with rubber O-rings, and self-adhesive rubber feet. The screws are black zinc plated to ASTM B633-13 (Type II, SC3), and the recommended screw torque is 5 lbf/in. If wall mounting is needed, the flanged equivalent is 1457J1602E; this part uses plain flat end panels. The part is RoHS and REACH compliant.