The Fortinet FANT-7IN1-RND-5M is a rugged 7-in-1 outdoor antenna for cellular-equipped Fortinet deployments. It works with FortiGate (FG), FortiGate Rugged (FGR), FortiExtender (FEX) and FEV models. Seven antennas share one round housing, 160 mm in diameter, so a single roof or pole location covers WAN, Wi-Fi client and positioning. This suits fleet vehicles, kiosks, remote cabinets and branch sites where the router sits indoors or inside a vehicle and the signal is outside. Four 5G/4G LTE MIMO elements cover 600 MHz to 6 GHz. That span runs from low-band Band 71 through the 3.3-3.8 GHz mid-band range. Fortinet publishes support for 5G NR FR1, LTE, LTE-Advanced, WCDMA and HSPA+ bands including 2, 4, 5, 12, 13, 14, 25, 41, 48, 66 and 71. Peak gain reaches up to 6.28 dBi on the cellular elements. The cellular and Wi-Fi elements are omnidirectional and linearly polarized, rated at 50 Ω and 2W maximum input. The two Wi-Fi MIMO elements cover 2.4 and 5.8 GHz, with up to 7.03 dBi peak gain at 5 GHz. The GNSS element is an active RHCP patch with a front-end SAW filter and low-noise amplifier, delivering 32.4 ±3 dBic total gain at 1575.42 MHz. It receives GPS L1, GLONASS G1, BeiDou B1C/B1I, Galileo E1, QZSS and SBAS. The cabling is integrated, with no field termination needed. It includes 5m TGC-200 runs for cellular and Wi-Fi and a 5m RG-174 run for GNSS. Cellular and GNSS leads end in SMA male connectors, and the Wi-Fi leads end in RP-SMA male. The IP67 polycarbonate enclosure is sealed with a rubber stopper and O-ring and is rated from -40°C to 85°C. It mounts directly to a vehicle roof through an M22 thread. Wall or pole installation uses a separately purchased mounting bracket. The antenna is RoHS and REACH compliant.